View Single Post
  #3   Report Post  
Posted to rec.woodworking
 
Posts: n/a
Default Plan for Cabbage Shredder

Thanks for taking the time to explain how the shredder works.
I was thinking of using some discarded surface (131/2") planer blades.
Then I realize that I still have an old good working 6"jointer entirely
build with aluminums.
I do not use it anymore because its too light. Maybe I should try to shred
a cabbage on it, just joking!
By relating it to how a jointer works you have given me a good picture. Now
I have to figure out how to secure the cutting blades.
Thanks again

"zap" wrote in message
k.net...
A Cabbage shredder -- I take it that you have never even seen one, and I
know that if you had ever used one that you would not have to ask the
question.

So here goes.

you have a two part base of wood, and a sharp thin blade. the in part of
the base is smooth and is about 3/4 the length of the entire cutter
assembly, and wide enough to take the largest cabbage. then a THIN sharp
blade is mounted just slightly higher than the in base board at the inside
end of the base, and goes from side to side. Set the height of the blade
to the hight to give you the thickness of cut that you want, and it will
be fixed in place and will not be changed after the unit is built. then
mount an output base board even with the top of your cutter blade for the
cabbage to slide on after going through the cutter. With two low side
pieces to hold the base boards and blade together and to keep the cabbage
from sliding off the base sides.

To use, set the cabbage slicer over a pan or bucket, and start pushing the
head of cabbage back and forth across the cutting blade. It works fast but
watch out that you do not slice your fingers. You could also make a push
block with very short teeth on the bottom by which you would hold the
cabbage down as you push it through.

Belive me, it will do a head of cabbage faster than you ever thought.

How it works? picture the top of a jointer. the input side is set lower
than the output side. I would suggest that you cut the cabbages in half
before starting to shred them. If the blade is held in with small screws,
then the blade can be removed for sharpening.

Have fun.

Zap

wrote:
I am looking at making a cabbage shredder or mandoline. Could someone
tell me where to go to get a plan or idea on how to make one.
TIA