In article .com, " wrote:
Looking for some suggestions with a issue I having with my Delta Table
Saw (36-320). 2000
Series.
The motor appears to be working and the blade is building up the
correct speed. However
when I go to cut the blade starts to slow down and stop after a few
seconds. The motor sound remains the same when the blad is stopped. I
am NOT feeding the saw a hardwood just some pine. The unit is beltless.

Have you checked to make sure the arbor nut is tight?

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.