View Single Post
  #8   Report Post  
Posted to uk.d-i-y
 
Posts: n/a
Default Removing HW Cylinder connector insert


John Rumm wrote:
wrote:

You need a 22mm solder ring tee, and a 22mm male to 15mm female end feed
fitting reducer.

Thanks John,

Great ascii art...I had seen this described on uk.diy some months ago
but was worried about flow rate through the 22mm to the pipe as its
internal cross section is reduced by the presence of the 15mm pipe to
the shower.

Has anyone tried this and obtained reasonable flow rates to the hot
taps (eg bath)?

Ian L