Copper plumbing fittings
Most of the sweat copper I've done, the pieces touched all around when I
pushed them together. Snug fit, too.
I remember o35, cause I used to gap Chrysler plugs that spec. WAAAAY too
much slop.
--
Christopher A. Young
You can't shout down a troll.
You have to starve them.
..
"Wayne Whitney" wrote in message
...
Hello,
For soldering copper pipe/tubing in the 1/2" to 1" range, what is the
proper size gap between the ID of the fitting and the OD of the
pipe/tubing? For example, the ID of 3/4" type L pipe is 0.785", while
the OD of 3/4" type L tube is 0.750"; would this be an acceptable
solder joint, or is 0.035" too big?
Thanks, Wayne
|