Wayne Whitney wrote:
Hello,
For soldering copper pipe/tubing in the 1/2" to 1" range, what is the
proper size gap between the ID of the fitting and the OD of the
pipe/tubing? For example, the ID of 3/4" type L pipe is 0.785", while
the OD of 3/4" type L tube is 0.750"; would this be an acceptable
solder joint, or is 0.035" too big?
Thanks, Wayne
Ah. I think you have confused copper pipe and tube used for
general plumbing apps with the "refrigeration tubing" used
on things like A/C systems. In the latter case, tubing is
always speced by the tube O.D. And there are special fittings
designed to accept those dimensions.
plumbing sizes:
http://www.copper.org/applications/p...th_table2b.htm
Refrig sizes:
http://www.rparts.com/Catalog/Instal...copper_t&f.asp