View Single Post
  #1   Report Post  
larry g
 
Posts: n/a
Default Boring head setup?

A few days ago I asked about boring with a lathe or mill. After weighing
ideas and my limited experience I am boring with the mill. Now the
question, what is the correct way to set the boring bar in the boring head?
My boring head is the 1 1/2 criterion square head. To set it up I installed
the bar, laid the whole assembly on the surface plate and used a square to
set the cutter parallel with the centerline of the head. I figure this
should give a zero rake at the cut, as I'm cutting brass. So far so good.

So is there a correct way to set the tool in a boring head?
lg
no neat sig line