|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
May 4th 05, 06:19 PM
|
|||
|
|||
Bostitch N80SB
The trigger valve on my Bostitch N80SB went out. The manual says to use
TVA11 to replace it but the Bostitch website says to use TVA6. I called Bostitch to check whether that was a mistake or not & the girl on the phone said I could use either one but she didn't sound real sure of herself. Does anyone know if that's true? Thanks Jim 
    
|
| Ads |
|
#2
May 5th 05, 10:49 AM
|
|||
|
|||
|
This might be of some help. Cheers, JG
http://www.bostitch.com/default.asp?...ft_tooldoc.htm Jim wrote: The trigger valve on my Bostitch N80SB went out. The manual says to use TVA11 to replace it but the Bostitch website says to use TVA6. I called Bostitch to check whether that was a mistake or not & the girl on the phone said I could use either one but she didn't sound real sure of herself. Does anyone know if that's true? Thanks Jim
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bostitch staple question | WilliaJ2 | Woodworking | 3 | October 19th 04 01:15 AM |
| Porter Cable vs. Bostitch Finish Nailer Combo Kits | Mark Witczak | Woodworking | 16 | September 5th 04 02:22 PM |
| Will Santa will fall through the roof? - AKA - Bostitch or Porter Cable Roofing Nailer? | Dr. Know | Woodworking | 7 | November 8th 03 08:36 PM |
Linear Mode
