DIYbanter

DIYbanter (https://www.diybanter.com/)
-   UK diy (https://www.diybanter.com/uk-diy/)
-   -   Ripped roofing felt: patch up with duck tape? (https://www.diybanter.com/uk-diy/109940-ripped-roofing-felt-patch-up-duck-tape.html)

[email protected] June 14th 05 10:48 AM

Ripped roofing felt: patch up with duck tape?
 
While I was up in the loft last evening, fitting some loft insulation,
I noticed a 6 inch rip in the roofing felt. I could view the roof tiles
through it.

There is no evidence of water ingress. Can I safely patch this up with
duck tape or do I need a more watertight solution?

Thanks
Bruce


Lobster June 14th 05 11:13 AM

wrote:
While I was up in the loft last evening, fitting some loft insulation,
I noticed a 6 inch rip in the roofing felt. I could view the roof tiles
through it.

There is no evidence of water ingress. Can I safely patch this up with
duck tape or do I need a more watertight solution?


Providing it sticks OK, I would have thought that should be fine. It's
not as if roofing felt is subject to massive amounts of running water -
you'll find old houses don't even have it at all. Keep an eye on it to
make sure it stays stuck down.

--
David

[email protected] June 14th 05 11:40 AM


Providing it sticks OK, I would have thought that should be fine. It's
not as if roofing felt is subject to massive amounts of running water -
you'll find old houses don't even have it at all. Keep an eye on it to
make sure it stays stuck down.


Thanks. What causes the rips -- birds, strong winds?

Bruce


Chris Bacon June 14th 05 11:51 AM

bruce_phipps wrote:
While I was up in the loft last evening, fitting some loft insulation,
I noticed a 6 inch rip in the roofing felt. I could view the roof tiles
through it.

There is no evidence of water ingress. Can I safely patch this up with
duck tape or do I need a more watertight solution?


If you want to do a proper job, get some felt and Ruberoid adhesive,
cut off a length of felt to fit between the rafters, preferably
pushed on to the top of the rafter at each side by 1/4" or so,
rehearse fitting it and tucking it over the top of the existing
lower unholed length of felt, cut away any felt that's hanging
down from the hole (leave as much as poss), liberally apply
adhesive to the underside of the holed felt, up and down the
edge next to the rafters, fit new felt and prop it in place with
battens arranged like a plasterboarder's "dead man" on each side
and the middle of the felt, leave to set properly, remove props.

Andy Dingley June 14th 05 12:08 PM

On 14 Jun 2005 01:48:49 -0700, wrote:

There is no evidence of water ingress. Can I safely patch this up with
duck tape or do I need a more watertight solution?


I'd patch it with a small piece of roofing felt laid across the gap,
held down with gaffer tape. If possible, wedge it in mechanically.

Gaffer tap alone is more flexible than felt, so any movement will tend
to be concentrated at the tear and will work to pull the tape off. A
patch of felt laid on top or underneath acts as a stiffener.

[email protected] June 14th 05 12:36 PM


There is no evidence of water ingress. Can I safely patch this up with
duck tape or do I need a more watertight solution?


I'd patch it with a small piece of roofing felt laid across the gap,
held down with gaffer tape. If possible, wedge it in mechanically.

Gaffer tap alone is more flexible than felt, so any movement will tend
to be concentrated at the tear and will work to pull the tape off. A
patch of felt laid on top or underneath acts as a stiffener.


Yes, I accept what you say. But I would have to buy a full roll of
roofing felt.
I'll have a look in Wickes. They'll probably have some sort of
heavy-duty repair tape, I expect.

Bruce


Dave Plowman (News) June 14th 05 12:45 PM

In article .com,
wrote:
Thanks. What causes the rips -- birds, strong winds?


Probably as installed. ;-)

--
*'ome is where you 'ang your @ *

Dave Plowman London SW
To e-mail, change noise into sound.

keith_765 June 14th 05 01:44 PM


wrote in message
oups.com...

Providing it sticks OK, I would have thought that should be fine. It's
not as if roofing felt is subject to massive amounts of running water -
you'll find old houses don't even have it at all. Keep an eye on it to
make sure it stays stuck down.


Thanks. What causes the rips -- birds, strong winds?

Bruce

Big footed roof tiler, Who should have repaired it in the first place when
the roof was being tiled.

How big a rip is it ?.
If its a small rip, just push back and stick tape over. If its a large rip,
its best done from out side but a lot of trouble.



[email protected] June 14th 05 01:53 PM

wrote:

There is no evidence of water ingress. Can I safely patch this up with
duck tape or do I need a more watertight solution?


I'd patch it with a small piece of roofing felt laid across the gap,
held down with gaffer tape. If possible, wedge it in mechanically.

Gaffer tap alone is more flexible than felt, so any movement will tend
to be concentrated at the tear and will work to pull the tape off. A
patch of felt laid on top or underneath acts as a stiffener.


Yes, I accept what you say. But I would have to buy a full roll of
roofing felt.
I'll have a look in Wickes. They'll probably have some sort of
heavy-duty repair tape, I expect.

Bruce


If theres no water coming in you dont need to do anything. Lots of old
houses have no felt at all.


NT


[email protected] June 14th 05 02:22 PM

Thanks.
I've bought some flashing tape from Wickes, =A35. I'll patch it up with
that.

Bruce



All times are GMT +1. The time now is 09:24 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter