Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to rec.crafts.metalworking
external usenet poster
 
Posts: 790
Default fa - special washing machine tool

some time back, there was a very lengthy set of threads on washing machine
repair - for one or two of you, this tool may be of great value, or at least
interesting - specialty bearing and motor pulley puller for a range of
machines

http://cgi.ebay.com/ws/eBayISAPI.dll...m=300182761612


--
bill
to email me, to to my web page, www.wbnoble.com and find my email



--
Posted via a free Usenet account from http://www.teranews.com

  #2   Report Post  
Posted to rec.crafts.metalworking
external usenet poster
 
Posts: 11
Default fa - special washing machine tool

Our old washer ( Kenmore 1995) stopped pumping the water out on the spin
cycle.. Upon dis-assembly I found the water pump to have worn out, plus the
bushings for the basket drive were shot- pretty simple except for the odd
size spanner nut holding the basket was very tight and made of aluminum.
Hammer and punch did not budge it, and it looked like it might break before
it came loose. Local Kenmore store said it was a " non repairable" item and
I should buy a new washer ( and matching dryer of course, since no wife will
accept a mis matched pair) Found a piece of pipe in the scrap that was the
same diameter as the nut, milled some slots into it to match the spanner
nut, welded a flat bar across the end of the pipe and welded a nut to the
flat bar at the center point, and voila- used my impact wrench on the whole
mess and the spanner nut came right off. Replaced the bushings and water
pump and much to my wife's dismay, the old set is back in action.

"William Noble" wrote in message
.. .
some time back, there was a very lengthy set of threads on washing machine
repair - for one or two of you, this tool may be of great value, or at

least
interesting - specialty bearing and motor pulley puller for a range of
machines

http://cgi.ebay.com/ws/eBayISAPI.dll...m=300182761612


--
bill
to email me, to to my web page, www.wbnoble.com and find my email



--
Posted via a free Usenet account from http://www.teranews.com



Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
is there a special tool? [email protected] Home Repair 12 July 19th 07 09:40 AM
A Special Tool Lew Hodgett Woodworking 4 March 18th 05 02:47 AM
Need Special Tool - Any Leads? Joe AutoDrill Metalworking 13 December 11th 04 06:27 PM
Shelf sockets - special tool for insertion? RichardS Woodworking 1 August 6th 03 11:51 AM


All times are GMT +1. The time now is 11:34 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"