|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
August 2nd 07, 03:43 AM
posted to rec.crafts.metalworking
|
|||
|
|||
Preperation guide for Sieg X3 small mill
This is pretty good. I think any X3 owner could do good by looking at it.
http://www.arceurotrade.co.uk/prepgu...on%20Guide.pdf 
|
| Ads | |
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Work and holder weight limits for Grizzly G0463 mill (Sieg X3 SmallMill) | Louis Ohland | Metalworking | 2 | May 19th 06 09:06 PM |
| Needs suggestions for a small mill and lathe. | Jon R. Pickens | Metalworking | 27 | February 27th 06 09:51 PM |
| small mill for home shop | Mike Berger | Metalworking | 30 | December 14th 05 08:43 PM |
| small mill | Steve Koschmann | Metalworking | 4 | November 4th 05 05:45 PM |
| Small mill advice | BP | Metalworking | 12 | August 13th 04 09:13 PM |
Linear Mode
