Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to rec.crafts.metalworking
Richard W.
 
Posts: n/a
Default Garage heat with a 9.6 kW electric heater


"Ignoramus24987" wrote in message
...
I have a approximately 20x20 ft attached garage. Sometimes I want to
make it warm quickly. Often I am there for relatively short periods of
time (because I am constantly interrupted).

I bought a 9.6 kW, 240V duct heater on ebay. It has a 24V control and
various overheat protections.

My plan is to enclose it into a welded frame and sheet metal (found a
few nice sheets in a hospital dumpster), add a fan to it and a 24V
control system using a thermostat. I also have a grill type thing that
I can use to protect the coils from little curious fingers and
flammables.

My idea is to make something relatively compact (say 2x2x1.5 ft), that
I would set on the floor, turn on and get the garage warm in a few
minutes rather than wait for a long time. I would save some
electricity by only heating the garage when I need it, rather than
warming it up "just in case".

What I am looking for is some feedback on safety and such.

i


I bought a 4,000 watt 220 volt electric heater for my garage in the old
house. The thermostat was built in and it came with a bracket to hang on the
wall. All I had to do was put a 220 outlet where I installed the heater. The
garage was 24 X 24 and insulated. Get up in the morning and turn the heat
on, then eat breakfast. By then the shop was nice and warm.

http://www.northerntool.com/webapp/w...58&R=10 49858

If you have no insulation then you may want a larger one. Also the one I got
you could run just the fan in the summer. By having it mounted on the wall I
saved quite a bit of floor space over the old oil stove I took out.


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Garage heat with a 9.6 kW electric heater Glenn Metalworking 3 January 3rd 06 12:16 AM
Garage heat with a 9.6 kW electric heater spaco Metalworking 0 December 30th 05 06:54 PM
Which is more economical - electric or natural gas water heater? daestrom Home Repair 0 December 4th 05 02:58 PM
Above ground pool heaters - Gas heater vs. Electric heat pump ack123 Home Ownership 1 June 15th 05 04:39 PM
Electric Heater Denver Woody Woodworking 6 October 2nd 03 09:43 PM


All times are GMT +1. The time now is 05:24 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"