Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Basha
 
Posts: n/a
Default Garage electric outlets not working

Hi,

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok. I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from? Is there
anything I can do from my side or is it better to call an electrician?

Thanks for help.

Basha
  #2   Report Post  
Speedy Jim
 
Posts: n/a
Default

Basha wrote:

Hi,

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok. I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from? Is there
anything I can do from my side or is it better to call an electrician?

Thanks for help.

Basha


TEST and RESET each GFCI receptacle.

Switch the GFCI circuit breaker to the OFF position and then back ON.

Sometimes they can look like they are On when not.

Jim
  #3   Report Post  
WORSS
 
Posts: n/a
Default

Basha,

You need to determine where you have power and where you do not. I suspect
that there is another GFCI that you are not aware of that may have
tripped....look again. If not, you need to buy a cheap circuit tester at
your local hardware store. Some only need to be close to detect power. You
then need to see where your power stops. It must either be a tripped GFCI,
a bad breaker, or a disconnected wire. Also, try turning the breaker off
and then back on...sometimes it is hard to tell when they have tripped. If
you don't know what you are doing, call an electrician.

Bill
"Basha" wrote in message
m...
Hi,

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok. I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from? Is there
anything I can do from my side or is it better to call an electrician?

Thanks for help.

Basha



  #4   Report Post  
Tony Hwang
 
Posts: n/a
Default



Basha wrote:

Hi,

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok. I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from? Is there
anything I can do from my side or is it better to call an electrician?

Thanks for help.

Basha


Hi,
Some times good looking GFCI breakers can be bad. Have a multi-meter?
Get an El Cheapo one if not, very handy for trouble-shooting.
Tony
  #5   Report Post  
Rich
 
Posts: n/a
Default

Get yourself a good circuit tester such as the
A.W. Sperry CS-600A to find the breaker.
Rich
http://www.garage-door-hardware.com


"Basha" wrote in message
m...
Hi,

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok. I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from? Is there
anything I can do from my side or is it better to call an electrician?

Thanks for help.

Basha





  #6   Report Post  
Rudy
 
Posts: n/a
Default


TEST and RESET each GFCI receptacle.

Switch the GFCI circuit breaker to the OFF position and then back ON.

Sometimes they can look like they are On when not.


If that doesnt work..Keep looking, theres another one


  #7   Report Post  
TOM
 
Posts: n/a
Default

Several replies about finding a GFCI are usually correct. Back in the
1990's, the GFCI outlets could be hidden almost anywhere - today
they are usually closer to the affected outlet.

Sneaky places the GFCI may be located:

Bathroom. Usually needed here, it may feed the garage.
Kitchen. Sometimes underneath the sink feeding the garbage
disposal, may also feed the garage.
Water heater closet. Will not feed an electric water heater,
but sometimes the closet is close to the garage, and the
GFCI may be hidden in there just because it's convient.

-- Tom



"Basha" wrote in message
m...
Hi,

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok. I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from? Is there
anything I can do from my side or is it better to call an electrician?

Thanks for help.

Basha



  #8   Report Post  
slushfund
 
Posts: n/a
Default

check the bathroom


  #9   Report Post  
Tekkie
 
Posts: n/a
Default

Basha posted for all of us....

Hi,

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok. I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from? Is there
anything I can do from my side or is it better to call an electrician?

Thanks for help.

Basha

Like the other answers it's a GFCI somewhere, look for outside outlets too.
--
Tekkie
  #11   Report Post  
Himanshu
 
Posts: n/a
Default

Basha wrote:

I recently moved into my first house (year built 1993). After a week,
I noticed that the electric outlets in the garage not working along
with one outlet outside just adjacent to garage. I checked all the
GFCIs. I checked all the circuit breakers. They look ok.


Even if the breakers look ok, try switching them off-and-on.

I got onto
the attique and couldn't find where those outlets are feeding from.
The grage door opener and the light bulbs in garage are working fine.
They are fed from seperate line. Is there a way that I can
troubleshoot/find out where these outlets are feeding from?


Since I was alone and kept going up-and-down from the attic to the
basement and into-and-out of several rooms, it took me a few hours to
figure out the wiring in a house that I moved into. However, it depends
on how much of your wiring is visible and/or accessible.

Correlate the wiring with circuit breakers - if you know which circuit
breaker controls which outlet/receptacle, then start from there and
trace the wiring to other outlets and receptacles till you figure out
each circuit. If you do this one circuit at a time and draw it on a few
pieces of paper, you'll have complete understanding of the wiring in
your house, which will help in the long run.

--
Himanshu
  #12   Report Post  
John Gilmer
 
Posts: n/a
Default




TEST and RESET each GFCI receptacle.

Switch the GFCI circuit breaker to the OFF position and then back ON.

Sometimes they can look like they are On when not.


Yep. Sometimes that "fail open."

Take the cover off and use a VOM or a neon test to see whether you have
power coming to the GFCI. If you do, REPLACE it. If you don't look "up
stream."

Jim



Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
GE HTS22GBMARWW Digital Controls refrig 22 cu ft.....main bord failure number #3! henrib7 Home Repair 7 June 13th 04 09:30 AM
Heated Floor (electric) not working RD Home Repair 12 December 1st 03 06:32 PM
Cutting floor tiles: Electric or Hand Operated cutter? Serial Bodger UK diy 12 August 17th 03 02:36 PM
Making a ruin into something habitable. Liz UK diy 140 August 12th 03 12:03 PM


All times are GMT +1. The time now is 08:51 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"