A DIY & home improvement forum. DIYbanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » DIYbanter forum » Do - it - Yourself » Home Repair
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems.

Bryant code 13



 
 
LinkBack Thread Tools Display Modes
  #1  
Old January 15th 07, 07:28 PM posted to alt.home.repair
external usenet poster
 
Posts: 5
Default Bryant code 13

Hi all, the ducts from my furnace had a bit of a burnt smell a couple
days ago, so I check the metal mesh filters inside the Honeywell
electronic air filter and they were quite dirty so I cleaned them and
things seemed to be fine. However, several times over the next couple
days, I heard a strange noise from the furnace, like a whooshing power
down noise. Then this morning I awoke to no heat and checked the red
blinking light on the Bryant furnace (2-cycle). It was one long blink
and three short..code 13. The sticker on the side (for code 13) says
auto reset after three hours, FRS Flame Roll-out Switch requires
manual reset.

I turned power off and on, and red light came on steady and things
started to fire up, however blower never came on and then red light
started blinking code 13 again. I never did do a manual reset of the
FRS because I did not see any reset switches. Is this something I can
do myself, or is a technician required.

Also of note, there is a small circuit breaker type plug that has 4
very small switches: BLOWER OFF, DELAYS, LO HEAT, HI HEAT. The switch
for the BLOWER OFF is ON, the other three are in the OFF position. Can
I reset the OFF ones to ON?

Thanks for the help, and I will be calling a technician, however, I
just wanted to check if I'm missing out on something fairly
straightforward. Thanks for any input!

Ads
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
Bryant/Carrier vs. Trane Laura Home Ownership 2 June 30th 06 04:59 PM
I want to test C#code ,how Can i study ,? I want to get C# code What site.? [email protected] Home Repair 6 June 13th 06 06:33 AM
Bryant furnace-- code 34? cerealtrader Home Repair 3 March 13th 06 08:20 PM
Bryant Evolution control [email protected] Home Repair 0 November 22nd 05 04:18 PM
Trane vs. Bryant vidbex Home Repair 4 November 10th 05 06:32 PM


All times are GMT +1. The time now is 03:59 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.SEO by vBSEO ©2010, Crawlability, Inc.
Copyright ©2004-2014 DIYbanter.
The comments are property of their posters.