My washing machine drain hose inserts into a drain pipe just larger than the
drain hose. Problem is some water is not shooting down the pipe. There is
a elbow about 6-8inches down from where it inserts.

Any suggestions on adapting this?

I have no laundry tub

Duct Tape?

Worked for me.

"Gary Niskanen" wrote in message
news:k3C1g.933812$xm3.779763@attbi_s21...
My washing machine drain hose inserts into a drain pipe just larger than
the drain hose. Problem is some water is not shooting down the pipe.
There is a elbow about 6-8inches down from where it inserts.

Any suggestions on adapting this?

I have no laundry tub

The outlet of my drain hose is 1-1/4 and the drain pipe is 1-1/2 PVC so
it was easy to install a threaded adapter from the local hardware store and
top it off with a nut and rubber washer borrowed from a J trap. With the
tight fit, air can no get in to break any possible suction on the drain pipe
so I teed off the drain pipe and installed an air admittance valve higher
than the drain hose. Perhaps overkill on that.

Bob

Maybe you could just add a couple of inches to the top of the pipe. I
think the installation instructions for my washer specified a minimum
height before the trap.

I didn't read the instructions though, I just glanced at them and my
eyes started to burn.