Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Frogleg
 
Posts: n/a
Default Partial power outage?

Power went out here in a very odd way the other day, and I can't get
through to power co. for an explanation. Flourescent lights in one
room flickered, dimmed, and went out. Radio lost volume and then went
out. Computer stayed on (with CRT monitor) quite happily until I shut
it down. 'Fridge stayed on. Some incandescent lights would switch on
normally; others wouldn't. Little clock radio quit; light plugged into
same outlet worked. Flourescent in another room remained on.

Electric co. said problem was a neighborhood transformer, and a couple
of blocks were affected, not just my house. So what kind of a failure
is it when some electricity works and some doesn't? I've always
thought of it as an on/off situation.
  #2   Report Post  
Duane Bozarth
 
Posts: n/a
Default

Frogleg wrote:

Power went out here in a very odd way the other day, and I can't get
through to power co. for an explanation. Flourescent lights in one
room flickered, dimmed, and went out. Radio lost volume and then went
out. Computer stayed on (with CRT monitor) quite happily until I shut
it down. 'Fridge stayed on. Some incandescent lights would switch on
normally; others wouldn't. Little clock radio quit; light plugged into
same outlet worked. Flourescent in another room remained on.

Electric co. said problem was a neighborhood transformer, and a couple
of blocks were affected, not just my house. So what kind of a failure
is it when some electricity works and some doesn't? I've always
thought of it as an on/off situation.


One side of 240 supply failed...so what was on that side through your
distribution panel also failed.
  #3   Report Post  
toller
 
Posts: n/a
Default

A few years ago my office lost 1/3rd of the circuits. Turns out a branch
had fallen on one wire of the 3 phase feeding my building.
I was urged to immediately unplug anything that used more than 120 because
it might get insufficient voltage.

Obviously you don't have 3 phase, but I expect something happened to the
transformer so you only got one leg of the 240v.


  #4   Report Post  
Colbyt
 
Posts: n/a
Default


"Frogleg" wrote in message
...
Power went out here in a very odd way the other day, and I can't get
through to power co. for an explanation. Flourescent lights in one
room flickered, dimmed, and went out. Radio lost volume and then went
out. Computer stayed on (with CRT monitor) quite happily until I shut
it down. 'Fridge stayed on. Some incandescent lights would switch on
normally; others wouldn't. Little clock radio quit; light plugged into
same outlet worked. Flourescent in another room remained on.

Electric co. said problem was a neighborhood transformer, and a couple
of blocks were affected, not just my house. So what kind of a failure
is it when some electricity works and some doesn't? I've always
thought of it as an on/off situation.


The simple explanation is that power is supplied to homes with 2 hot wires
and one neutral wire. Half (an over-simplification) of the stuff in your
home uses one of the hots and the other half uses the other. Stoves,
electric heat and AC units use both hots.

If one leg (one of the hots) is not working some of your stuff will work
and the rest of it won't.


Colbyt



  #5   Report Post  
Scott Townsend
 
Posts: n/a
Default

I like to call them Brown Outs. (-;

"Frogleg" wrote in message
...
Power went out here in a very odd way the other day, and I can't get
through to power co. for an explanation. Flourescent lights in one
room flickered, dimmed, and went out. Radio lost volume and then went
out. Computer stayed on (with CRT monitor) quite happily until I shut
it down. 'Fridge stayed on. Some incandescent lights would switch on
normally; others wouldn't. Little clock radio quit; light plugged into
same outlet worked. Flourescent in another room remained on.

Electric co. said problem was a neighborhood transformer, and a couple
of blocks were affected, not just my house. So what kind of a failure
is it when some electricity works and some doesn't? I've always
thought of it as an on/off situation.





  #6   Report Post  
JohnR66
 
Posts: n/a
Default

"Colbyt" wrote in message
news:2AWAe.167770$xm3.93973@attbi_s21...

"Frogleg" wrote in message
...
Power went out here in a very odd way the other day, and I can't get
through to power co. for an explanation. Flourescent lights in one
room flickered, dimmed, and went out. Radio lost volume and then went
out. Computer stayed on (with CRT monitor) quite happily until I shut
it down. 'Fridge stayed on. Some incandescent lights would switch on
normally; others wouldn't. Little clock radio quit; light plugged into
same outlet worked. Flourescent in another room remained on.

Electric co. said problem was a neighborhood transformer, and a couple
of blocks were affected, not just my house. So what kind of a failure
is it when some electricity works and some doesn't? I've always
thought of it as an on/off situation.


The simple explanation is that power is supplied to homes with 2 hot wires
and one neutral wire. Half (an over-simplification) of the stuff in your
home uses one of the hots and the other half uses the other. Stoves,
electric heat and AC units use both hots.

If one leg (one of the hots) is not working some of your stuff will work
and the rest of it won't.


Colbyt


And... Any 240 volt devices that are energized would "back feed" the open
leg. Due to loads on the open leg, the voltage would be low, but present. Be
sure to shut off any motorized or electronic appliances that could become
damaged.
John


  #7   Report Post  
Mike Dobony
 
Posts: n/a
Default


"JohnR66" wrote in message
...
"Colbyt" wrote in message
news:2AWAe.167770$xm3.93973@attbi_s21...

"Frogleg" wrote in message
...
Power went out here in a very odd way the other day, and I can't get
through to power co. for an explanation. Flourescent lights in one
room flickered, dimmed, and went out. Radio lost volume and then went
out. Computer stayed on (with CRT monitor) quite happily until I shut
it down. 'Fridge stayed on. Some incandescent lights would switch on
normally; others wouldn't. Little clock radio quit; light plugged into
same outlet worked. Flourescent in another room remained on.

Electric co. said problem was a neighborhood transformer, and a couple
of blocks were affected, not just my house. So what kind of a failure
is it when some electricity works and some doesn't? I've always
thought of it as an on/off situation.


The simple explanation is that power is supplied to homes with 2 hot

wires
and one neutral wire. Half (an over-simplification) of the stuff in your
home uses one of the hots and the other half uses the other. Stoves,
electric heat and AC units use both hots.

If one leg (one of the hots) is not working some of your stuff will

work
and the rest of it won't.


Colbyt


And... Any 240 volt devices that are energized would "back feed" the open
leg. Due to loads on the open leg, the voltage would be low, but present.

Be
sure to shut off any motorized or electronic appliances that could become
damaged.
John



Yup! My f-i-l had that happen. When he turned on the stove, everything
worked. Turned out the feed to his outside box was too short and the
freezing pulled it out of the breaker. The electric company had to come in
and put in a longer feed line.


  #8   Report Post  
CL (dnoyeB) Gilbert
 
Posts: n/a
Default

Frogleg wrote:
Power went out here in a very odd way the other day, and I can't get
through to power co. for an explanation. Flourescent lights in one
room flickered, dimmed, and went out. Radio lost volume and then went
out. Computer stayed on (with CRT monitor) quite happily until I shut
it down. 'Fridge stayed on. Some incandescent lights would switch on
normally; others wouldn't. Little clock radio quit; light plugged into
same outlet worked. Flourescent in another room remained on.

Electric co. said problem was a neighborhood transformer, and a couple
of blocks were affected, not just my house. So what kind of a failure
is it when some electricity works and some doesn't? I've always
thought of it as an on/off situation.


Yes, thats the term commonly used around here. Brown out. Its
dangerous for some appliances, mostly motors/compressors. Unplug the
refridgerator.

Yes this is transformer problem. The beauty of the setup is you can
buron out one of the phases of a transformer, and it will keep doing its
job. It just has less power to give out. Unfortunately if you burn a
few out, and the transformer gets loaded, the voltage will start to drop
then.


--
Respectfully,


CL Gilbert
  #9   Report Post  
Frogleg
 
Posts: n/a
Default

Thanks to all for replies. And please pray for 'fridge. Thought it was
miraculous that it kept working. :-(
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Workshop In An Alternate Homepower Environment Too_Many_Tools Metalworking 288 June 29th 05 11:10 AM
Power surges 1/ 2 barry martin Home Repair 0 June 5th 04 10:48 AM
Power cost of idle electric water heater Phil Sherrod Home Repair 57 April 2nd 04 10:51 PM
Generator FAQ Gunner Metalworking 0 January 23rd 04 05:24 PM
Power outage question WbSearch Electronics Repair 5 August 16th 03 11:41 PM


All times are GMT +1. The time now is 01:08 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"