Home Ownership (misc.consumers.house)

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Niel
 
Posts: n/a
Default Electric Stove Not Hot Enough

New house (to us) with 18-year-old Jenn-Air coil surface elements that
just don't get hot enough. Contacts seem good. Could it just need
new coil surface elements or sockets or both? I'd rather not buy a
whole new stove.
Also, 18-year-old GE oven doesn't seem to heat up to the set
temperature. Could it just need new heating elements or sockets or
both, too?
  #2   Report Post  
John R Weiss
 
Posts: n/a
Default

"Niel" wrote...
New house (to us) with 18-year-old Jenn-Air coil surface elements that
just don't get hot enough. Contacts seem good. Could it just need
new coil surface elements or sockets or both? I'd rather not buy a
whole new stove.
Also, 18-year-old GE oven doesn't seem to heat up to the set
temperature. Could it just need new heating elements or sockets or
both, too?


Check the electric supply. Is the voltage at the stove correct? if not, you
may need to check into the house wiring.

Check the sockets. Is there any dirt, grease, or corrosion built up? Remove
each element and check.

Check the oven temp. Get an oven thermometer and check the accuracy of the
thermostat.


  #3   Report Post  
Speedy Jim
 
Posts: n/a
Default

Niel wrote:
New house (to us) with 18-year-old Jenn-Air coil surface elements that
just don't get hot enough. Contacts seem good. Could it just need
new coil surface elements or sockets or both? I'd rather not buy a
whole new stove.
Also, 18-year-old GE oven doesn't seem to heat up to the set
temperature. Could it just need new heating elements or sockets or
both, too?


Check with a voltmeter to see that both appliances are actually
getting 240V.
It's possible that one side of the Line is open.

Jim
  #4   Report Post  
Donald Tsang
 
Posts: n/a
Default

In article ,
Niel wrote:
New house (to us) with 18-year-old Jenn-Air coil surface elements that
just don't get hot enough. Contacts seem good. Could it just need
new coil surface elements or sockets or both? I'd rather not buy a
whole new stove.


Is it possible that you have a 220v stove being powered by a 110v line?

(on a more serious note, are you used to cooking on electric? Electric
stoves certainly doesn't get as hot as gas stoves...)

Donald
  #5   Report Post  
John R Weiss
 
Posts: n/a
Default

"Donald Tsang" wrote...

(on a more serious note, are you used to cooking on electric? Electric
stoves certainly doesn't get as hot as gas stoves...)


I think you'll find that among regular-grade (not "commercial") stoves, electric
stoves are rated at a higher BTU output than gas stoves on the burners. They
take longer to heat up, but put out more heat once they get there.

Some of the newer glass-top and "InfraRed" electric burners may be lower, and
there may be a few "high-output" gas burners, but on average the electric stove
will boil a pot of water faster.


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
GE HTS22GBMARWW Digital Controls refrig 22 cu ft.....main bord failure number #3! henrib7 Home Repair 7 June 13th 04 10:30 AM


All times are GMT +1. The time now is 05:48 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"