Home Ownership (misc.consumers.house)

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #41   Report Post  
Posted to misc.consumers.house
external usenet poster
 
Posts: 1
Default How to avoid ice-clogged furnace air intake pipe?

Im having the same issues. I live in Alberta and its been around -35 to -42 the past few days and my 3€ intake keeps getting frost built up in the inside until my furnace shuts off or just blows cold air. Can I still increase the pipe diameter as soon As it leaves the house? It does have a 90 facing down and slightly away from the exhaust that goes straight out. Im getting tired of cleaning the frost out 3-5 times in 24 hours including the middle of the night.
  #42   Report Post  
Posted to misc.consumers.house
external usenet poster
 
Posts: 1
Default How to avoid ice-clogged furnace air intake pipe?

On Monday, January 13, 2020 at 5:58:11 AM UTC-7, wrote:
Im having the same issues. I live in Alberta and its been around -35 to -42 the past few days and my 3€ intake keeps getting frost built up in the inside until my furnace shuts off or just blows cold air. Can I still increase the pipe diameter as soon As it leaves the house? It does have a 90 facing down and slightly away from the exhaust that goes straight out. Im getting tired of cleaning the frost out 3-5 times in 24 hours including the middle of the night.


Hey all,

I have been reading up on these high efficiency furnaces because like Jroc said, it is cold in Alberta right now. Condensation is dripping from the exhaust and building up from the ground until it reaches the exhaust/intake. This has kicked the furnace off in the past, they are smart enough to recognize what's happening... it hasn't happened in the past couple years because I go and knock the ice off and away from below it.

Installation manuals for these furnaces require a 1/4" drop in 1 foot towards (yes towards) the furnace. 8' would be a 2" drop slanted towards the furnace. They have a system that manages the condensation and it drains into the floor drain. I have to change mine and try that. It only drops towards the furnace 1" in 10'.

Don't take my word for it, download a couple high efficiency furnace installation manuals.

Cheers,
W
  #43   Report Post  
Posted to misc.consumers.house
external usenet poster
 
Posts: 1
Default How to avoid ice-clogged furnace air intake pipe?

Trying to work out same issue on an Instant On Takagi Hot Water Heater using for radiant floor heat.
As soon as gets cold outside it would ice up. I had a fix that worked until it was below zero F, and since my install is high on ground level floor and exhaust exits just under soffits, was to add 2' extension to the exhaust. More condensate was forming inside the pipe and then dripping to ground vs turning side of cabin into a cloud making machine like a dryer vent.
My 'furnace' can handle up to 15' of venting before I need to flip some DIP switches to change and can handle vents longer than my house, so adding this small section was of no concern.
Now that it is -25F out there, and near zero wind, the small amount of plume is now a concern again and I was outside middle of night clearing ice off intake, and again 6 hours later.
I was tempted to add small heater to intake, as I bought one to warm up my ATV, small 15w unit, but think will just extend intake when can make another trip to hardware store.
Add a 90 and run away from exhaust. If I didn't just have the whole house sided and new soffits I would build some sort of diverter between the 2.
I thought going 3" when 2" was only required due to short length would work, 1st heating season new system, guess I was wrong. At least with in floor heating, if it kicks off middle of night I only lose a few degrees of internal temps. They need to design a better intake/exhaust system for use in colder climates. Some low volt DC heater on intake with humidistat and thermostat sensors to trigger the need for heating. Or possibly reversing the intake and exhaust so warm air blows out intake and melts the buildup? Engineers get to work, this should not be upon the homeowner.
And if those ideas makes someone rich here, please come out and upgrade my system, I am too old for late night trips out in -40F windchills.

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Oil Furnace Intake Vent David Home Repair 5 November 22nd 05 03:59 AM
Furnace - increase air intake. [email protected] Home Repair 8 October 26th 05 03:22 PM
frost buildup on furnace intake Earl Home Repair 3 February 7th 05 02:16 PM
Gas Furnace Intake Freezup Problem John Home Repair 1 January 25th 05 06:43 AM


All times are GMT +1. The time now is 06:24 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"