Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 172
Default LCD TV Repair Training Manual/Book Source

Hi,

A few months ago I looked for a LCD TV repair training manual/book
at Amazon, Border's, Walden's, etc.

Do you know of a source for such a manual/book?

Thank You in advance, John

PS, Remove "ine" from my email address

  #2   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 3,833
Default LCD TV Repair Training Manual/Book Source

Given the overall decline in the service industry, and the way modules are
returned for factory repair -- or products are simply thrown away -- it's
unlikely there are any such books.


  #4   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 6,772
Default LCD TV Repair Training Manual/Book Source


wrote in message
...
Hi,

A few months ago I looked for a LCD TV repair training manual/book
at Amazon, Border's, Walden's, etc.

Do you know of a source for such a manual/book?

Thank You in advance, John

PS, Remove "ine" from my email address


To be honest, there's not an awful lot to repair on them. By far and away,
the two commonest problems are the power supplies, and backlight inverters.
The power supplies are just generally just multi-stage switchers (standby
supply, PFC supply and main supply - that's effectively three mostly
independant switchers on one board). Most failures are fairly obvious. Chips
with the tops blown off, bulging or open circuit caps, bad lead-free joints
etc. Most boards have 'repair kits' available for them, where you just
replace everything that comes in the kit, and turn back on. 99% of cases,
that is then an end to the problem. Most TV switchers are pretty well
behaved, once they have been properly repaired. Also, there are not all that
many different types. An awful lot of LCD TVs are just badged from a few
different manufacturers, and you will quickly see similar if not identical
modules popping up in sets that are completely different on the outside.

Worst case, if you really can't fix a particular power supply, the whole
module is often available at an unrealistically cheap price from either the
manufacturer, or their spares agent. If the name on the front is something
obscure, you may well recognise the supply as being the same as one fitted
to a major brand set. You can then just buy one of those instead.

The biggest problem is schematics. Even if you can get a schematic set for
the whole TV, you will often find that the PSU is shown just as a 'block'.
Spares can also be a problem, with 'obscure' surface mount devices often
being used. This ceases to be a problem if you use a repair kit, but in some
cases, these are 'shotgun', and may contain devices to fix several different
common problems, and thus cost a fair bit more than you would pay trade for
just the devices that are *actually* faulty. That said, unless you are very
experienced with switchers, I would always recommend replacing ALL of the
items that come in the kit, as sometimes, some little diode or whatever,
that appears to have nothing at all to do with the components that you
*have* found faulty, is actually the original cause of the cascade failure
that you thought that you had gotten to the bottom of ... :-(

Backlight inverter boards suffer from bad joints, bad transistors, bad
transformers, and bad caps for the most part. Again parts can be a problem,
and it is often better to source a replacement board, then keep the old one
to cull parts from for the future.

Other than that, there's not too much else that you're going to be able to
repair. For sure, you can get audio IC problems, and cap failures and so on
in other areas of the sets, but in general, main board failures are going to
be beyond the diagnostic abilities of a 'normally' equipped and trained
engineer.

Hope that is of some practical help to you.

Arfa


  #5   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 3,833
Default LCD TV Repair Training Manual/Book Source

Worst case, if you really can't fix a particular power supply, the
whole module is often available at an unrealistically cheap price...


Did the world suddenly change overnight?




  #6   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 6,772
Default LCD TV Repair Training Manual/Book Source


"William Sommerwerck" wrote in message
...
Worst case, if you really can't fix a particular power supply, the
whole module is often available at an unrealistically cheap price...


Did the world suddenly change overnight?



In this particular case William, yes. I can only assume that the
manufacturers heavily subsidise the cost of replacement PSU boards in order
to preserve their (good) name in the market place. They don't seem to have
caught on to the fact that engineers will often order one of these cheap
boards to fix a set that is from a completely different manufacturer, but
happens to use the same power supply, or even complete chassis. No chassis
number or serial number or old power supply return, is required. From some
sources, you don't even need to be trade.

If you look for instance at the Vestel 17PWxx series of power supplies, used
in a lot of different manufacturers' sets, and many of which are actually
interchangable if you know what you are doing, or have adaptor harnesses
(although almost identical circuitry-wise and physically, later versions
have slightly different connector pinning), you will find that the proper
price is anywhere around the £100 ($160) mark. However, they are for sale,
brand new from many sources, including manufacturers' direct spares agents,
for as little as £32 ($50). I do a repair service on them for a little less
than that.

These are a very complex and well built supply, and at least £80 is what you
would truthfully *expect* to pay for one.

Arfa


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Training Manual Book on Servicing LCD Televisions Brad Electronics Repair 1 April 22nd 09 06:19 AM
Woodworking Book Source J T Woodworking 0 January 3rd 08 05:49 PM
Home Repair Book/Manual Surprise Me Home Repair 6 August 19th 07 10:10 PM
book or manual pirovani Electronics Repair 1 September 29th 06 02:43 AM
WTD To Buy CTC170 Training or Service Manual MarkC Electronics Repair 1 October 25th 03 03:47 PM


All times are GMT +1. The time now is 11:08 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"