There was a thread on something similar back around mid March - see
following link :-
http://groups.google.co.uk/groups?hl...threadm=c34coe
%242c4djd%241%40athena.ex.ac.uk&rnum=1&prev=/groups%3Fq%3D%2522washing%2Bmac
hine%2522%2Bgrindng%2B%2Bgroup:uk.d-i-y%26hl%3Den%26lr%3D%26ie%3DUTF-8%26oe%
3DUTF-8%26group%3Duk.d-i-y%26selm%3Dc34coe%25242c4djd%25241%2540athena.ex.a c
..uk%26rnum%3D1
Several of the replies suggested something like the following
__________________________________________________ _______________
i have a 18-month old Hotpoint Aquarius (WMA36). Until recently it was
reasonably quiet, but during the spin it now has become very noisy. It
now
makes quite a loud "grinding" noise when it spins - a sort of
metal-on-metal
noise. Also, when you rotate the drum manually i can hear a sort of
"rachet/clicking" noise as the drum turns.
Anyone got any thoughts as to what it is likely to be? Dodgy bearings,
brushes, motor..???
At the risk of sounding obvious, the only time that this happened to me was
when a nail fell out of a pocket and went through one of the drum drain
holes and jammed there scraping on the outer drum. The same effect can be
got from coins, bra wires or other hardware. You may have to remove the seal
and look with a torch, but I would check this before dismantling more of the
machine!
__________________________________________________ _________-
HTH
Chris O
"James Onslow" wrote in message
om...
Hi,
My 5 yr old Creda w/m works fine except when it's on the last fast
spin. Once it gets to this it makes an awful "clackety, clackety" -
knocking sound which probably everyone in the whole block of flats can
hear.
I have taken all the panels off. There seems to be no play in the drum
or the motor. The fan belt is pretty tight. The spider looks fine. The
concrete blocks are all secure. The suspension rods look fine (but
that's as far as i could check with them). I got in the drum (as far
as possible anyway!) but I cannot see anything between the two drums.
So now I am stuck.
The noise seems to start as the machine picks up to a very high spin
but occasionally it seems to 'knock itself out' and sometimes stops
and the spin finishes quietly. It does sound as if there maybe
something loose.
There is a tiny bit of brown on the outer drum below the bearings but
not a great deal.
Can anyone help at all?
Many thanks, James