"Lovegod Tillman" wrote in message
nk.net...
Hi,

I have just bought a model 113.29991 ten-inch Sears Craftsman table saw.
It
is powered by a 3/4 HP sears motor rated at 1750 rpm (5/8 inch shaft). I
plan to replace the pullies but I'd like to be sure of the proper sizes.
Can
anybody give me some guidance on this? Much thanks.


Check your blade suggested rpm, or, as is usually the case, make it so the
blade rotates at about 4200 rpm. Arbor belt a touch smaller than half of
the motor.