Thread
:
Round oak table repair
View Single Post
#
2
igor
Posts: n/a
On 11 Jan 2005 08:42:31 -0800,
wrote:
I made some U shaped gluing cauls to glue the top up again. I can
probably get the lamination back on with 2 bar clamps and cauls, one on
top and one on the bottom as I can't overlap any due to the roundness.
However, there is another glue joint beginning to fail in the center
I'd like to drop some glue in and clamp too, but I can't figure out how
to clamp without making 2 huge cauls encompassing the entire top with
to apply clamps. If I need to make these, anybody have any tips???
Other ideas???
Would this help?
http://www.pennstateind.com/Merchant...gory_Code=CLPP
(watch out for wrap of link)
Reply With Quote