View Single Post
  #5   Report Post  
Sam Goldwasser
 
Posts: n/a
Default

"Robert Wolcott" writes:

I'll give that a try. This diode is part of a relative power meter on my
yag laser. The meter is currently not working and I'm not sure if it is the
diode or the circuit. The circuit can be seen at:

http://oregonstate.edu/~wolcottr/Yag...0schematic.jpg

Tests I have run include:

Measured the voltage supplied to the diode via BNC connector and it is 5.0
volts


Is the input 5 VDC or 12 VDC? 5 VDC wouldn't peg a 1 mAFS meter since
there is a 10K current limiting resistor.

placed a 1k resistor across the BNC connector and the power meter was
pegged.


Sounds consistent with 12 VDC input and the circuit working properly.

Hooked up the photodiode to the circuit and shined a 5mw diode laser into it
and there was no reading (direct illumination).


Do the tests above but sounds like it's bad.

Does this sound about right?


Yep. You can also test the photodiode on the diode check range of your
DMM. It should test like a silicon diode. I bet it tests open both ways.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.