View Single Post
  #4   Report Post  
richard p dawson
 
Posts: n/a
Default Furnace runs but have to manually restart

you are clueless sir, not on an 18 year old lennox.
where did you get this info?
Alt.home.repair ?




1991 Z28 wrote:

There is a sensor around the top of the burners usually held in by one screw
with a wire hooked up, remove the wire remove the sensor, clean with steel
wool or fine sand paper and replace.
"J. Jorgensen" wrote in message
om...
I'm having a problem with my furnace that I hope someone can shed some
light on. The furnace will run and then usually get to the desired
temperature set by the T-stat and stop. Then when the T-stat thinks
it should run again the the T-stat will show that the furnace is
running (it's an electronic T-stat), but the furance will not kick on.
If I am near the furnace, I can only hear a real faint buzzing sound
(which goes away if I shut the power off to the furnace). If I either
turn the T-stat off and on a few times or turn the power to the
furnace off and then on, the furnace will usually kick on (until the
next go around).

It seems to be a furance issue and not a T-stat issue, but I'm looking
for some help. Unless it is something really easy to fix, I plan on
calling a repairman, but I would still like to be knowledgable of the
problem beforehand.

It is a forced air Lennox furnce about 18 years old. I will mention
too that it started doing this a couple of days ago soon after I used
the electrical outlet on the furnace to power a shop vac (I rarely use
this outlet -- and I don't know if this would be related anyway).

Thanks.

Jim