"Zootal" wrote in message
. 97.131...
I have to cut a chunk of sheetrock out of a wall, approx. 2' x 5', to
repair some plastic water pipes (why do people use plastic in places like
this???). I'm going to replace the shower/tub valve, and replace all of
the
plastic with copper. This is the final stage of a repair job that I
started
a few weeks ago when a plastic (cpvc) pipe broke in the bathroom wall. I'm
basically replacing all of the plastic with copper, and putting in new
valves for the tub/shower, and toilets.

My question has to do with removing and replacing the sheetrock. I'm not
sure I can remove a piece this big intact, since it crosses a stud and is
screwed to the stud in a dozen places. Should I just hack it out of the
wall, or should I take the time to find and remove the screws so that I
can
remove it intact?

If I take the time and trouble to remove it intact, I can replace it with
minimal finishing work. If I replace it, I have to redo the texture that
is
on it so that it matches the rest of the wall. Any advice from those of
you
who have done this before?

Yes...just rip and tear....use a utility knife and steel square to make your
cuts straight and corners 90 degrees...... I just completed this job ...if
you have a spot where you want to match a piece of drywall to another piece
that does not have a stud backing, just slide a 2X4 on its side through the
hole and screw it to the good drywall leaving half of the 2x4 exposed to
screw the new piece to it on the inside... then you have something to secure
your patch to.... Jim