Paul wrote:
We are in the course of some fairly substantial building works. At the
start of November, we had some drains installed across the lounge
floor. Trenches were dug, drains installed, the trench filled with
shingle, and then concrete added on top of that to a depth of about
100mm below floor level. This was then blackjacked and another layer
of cement added to build it up to floor level.

Not knowing any better, we covered this with carpet, and a week ago
carpet layers were unable to lay a new carpet because it was
(unsurprisingly) too damp. Since then we have, of course, exposed it,
but it has not dried as quickly as expected.

If we have an ordinary fan play across it all night, it appears to
dry. But when the fan is removed, within 60 minutes it is damp again.
Oddly (or perhaps not), it is bone dry at the ends. Last night we
dried it with a hair drier, and the damp doesn't appear to have come
back so fast.

It is as if we can dry the top (say) 1mm, and then the damp comes back
from underneath.

If left to its own devices, how long will it take to dry please, and
how can we speed it up substantially please?

Many thanks,

Paul.

What do you mean by 'blackjacked'?

The concrete below is still wet, and will remain wet for a long time,
probably permanently, if you haven't installed a plastic membrane between
the top 100mm and this concrete, it will never dry out, as the moisture in
the ground will continue to soak into the concrete and up through the top
screed

--
Phil L
RSRL Tipster Of The Year 2008