View Single Post
  #1   Report Post  
Posted to uk.d-i-y
Peter[_2_] Peter[_2_] is offline
external usenet poster
 
Posts: 5
Default dado rail on stairs

I'm trying to run a dado rail on a wall going up a set of stairs and
then along a landing.

I can't work out how to cut the joint where the horizontal (landing)
run meets the stair wall run. Am I right in my guess that you set the
internal angle on a sliding bevel, measure it with a protractor, and
then halve it to get the right saw cut on both pieces?

They're in the same plane ie not turning a corner...

TIA
--
peter
--
Peter