View Single Post
  #2   Report Post  
Posted to alt.home.repair
Charlie Bress Charlie Bress is offline
external usenet poster
 
Posts: 118
Default Ignition Transformer for oil furnace Delco


"Len" wrote in message
ups.com...
My grandmother needs this igniton transformer,I can't find anything on
the net.Any replacement transformer that will work is fine.Here are
all the specs I have.Hope someone can help.

4924368 Type 52a-710x3

PRi,115 V.....250 V.A...... 60 CY

Sec 10,000......V.23 M.A.

Midpoint Grounded

E-12684

Delco Appliance Division

General Motors Corp.

Rochester N.Y.

I expect you might not find the exact item, but there are units out there
that should work OK if the mounting and connections are suitable.

The electrical requirements seem to be typical. The only spec that might be
a little off would the current of 23 mA. Anything above that would be OK. I
found one at the link below that was 22mA. For the application that would be
close enough.

http://www.dongan.com/products/ignitionframe.htm

Try a Google search for ignition transformer and check around. You might get
a good match by calling some of the suppliers and seeing if they have a
cross reference for the Delco number.

Charlie