I thought that was the purpose of the pivoting headstock--to rotate so that
I could accomodate larger bowls. Is that correct or did I misunderstand the
purpose of the pivoting headstock?

Chuck

"Patriarch" wrote in message
. 97.136...
"caaron" wrote in
:

I plan on turning bowls, mostly, so a Mini lathe is probably too small
for me. snip

If you're planning on turning bowls, you'll find that a 12" lathe, from
any
builder, is too small for much of your work...

Should you buy this one, don't plan on using it for your 'primary' for
very
long.

Patriarch, on his second...